Table of Contents
Advertisement
Setting the baud rate of the SCSI board
Set the SCSI baud rate of the SCSI board.
Check the model number of the board used, and set the
rate by following the procedure given.
When AHA-3940UWD is the SCSI board used
1. Power On.
2. Appear next comment when Boot Up.
Adaptec AHA-3940U/3940UW BIOS v1.xx
(c) 199x Adaptec, Inc. ALL Rights Reserved.
<<< Press <Ctrl><A> for SCSISelect(TM)Utility! >>>
3. Quickly press [Ctrl]+[A] keys when appear this com-
ment.
4. Run SCSI Utility and appear next window.
Use arrow key, select Channel(A or B), and press
[Enter] key.
You must change configuration both Cannel A and B.
5. Appear Menu window.
Select "Configure/View Host Adapter Setting", and
press [Enter] key.
15
6. Appear Configuration menu window.
Select "Advanced Configuration Options", press
[Enter] key.
7. Appear Advanced Configuration.
Select "Support for Ultra SCSI Speed", press [Enter]
key.
8. Appear Disabled , Enabled selectable.
Select "Enabled" and press [Enter] key.
Confirm "Enable" in Support for Ultra SCSI Speed.
Advertisement
Table of Contents
