Table of Contents
Advertisement
APPENDIX
How to install the board
Plug the AY-PB500 board (TARGA DV2000 board) into the PCI slot that is closest to the CPU (or the next closest slot, if
the board will not physically fit into the closest slot). Here, firmly mount the board spacer between the guide rails on the
computer. Screw down the cover (AY-PB500).
Then use the twist-tab wire to secure the board spacer to the guide rails inside the computer.
For a GATEWAY PC tower type
Board spacer (metal type)
Board spacer
twist-tab wire
Use the twist-tab wire to secure the board spacer to the guide rails inside the computer.
Twist the twist-tab wire and secure it properly.
Check that the board spacer has been secured properly.
Connect the ground wire to the computer's chassis only when the metal type of board spacer is supplied.
(Refer to page 11)
56
Guide rail
Board spacer (plastic type)
Board spacer
twist-tab wire
Guide rail
Advertisement
Table of Contents
