Panasonic AY-RP500 Installation Manual page 14

Nonlinear editing system control panel kit
Hide thumbs Also See for AY-RP500:
Table of Contents

Advertisement

5. Connect the CA-206 cable that was provided with
the TARGA DV2000 board.
labelled "TARGA DV2000" into the connector on the
TARGA DV2000 board, plug the connector labelled
"VGA" into the connector on the video card, and con-
nect the connector labelled "MONITOR" to the moni-
tor cable.
See page 7 and 32 for the VGA loop cable (CA-206).
6. Store the screws and cover that were removed in a
safe place.
7. Turn on the power and start up Windows NT.
8. Insert the software package CD-ROM into the CD-
ROM drive. Click
Start
Click "Run" on the start menu. The "Run" window
now opens.
Input "CD-ROM drive name:\targa\disk1\setup.exe"
in "Open:" and click OK. If, for instance, the CD-
ROM drive is drive d:, input the series of character
as shown above.
To check the letter assigned as the CD-ROM drive,
click "My Computer." The CD-ROM drive letter will
appear on the screen.
12
Plug the connector
.
9. Follow the instructions to install the driver from the
CD-ROM.
Operate according to the procedures
below.
1) The window for Truevision TARGA DV2000 Setup
appears.
Click
Next
.
2) The Product Type Inquiry window appears.
Select the type of board to use, and click
For analog type, select "TARGA DV2000" (default).
For SDI type, select "TARGA DV2000 SDX".
For SDI Voyager 2, select "TARGA DV2000 SDX V2".
(When the type is selected,
Refer to Appendix (The type of the SDI board)
about the type of the board.
3) The Choose Destination Location window apears.
Click
Next
.
4) The Select Program Folder window appears.
Click
Next
.
5) Installation begins.
6) The Readme window appears.
Click
on the upper-right of the window and
close it.
7) The Installation Completed Successfully window
appears.
Select "Yes, I want to restart my computer now".
(When this is selected,
Click
Finish
.
10. Restarts after installation.
At this point, remove the CD-ROM from which the
driver was installed.
11. When Windows NT has restarted, click
From Programs in the Start Menu, click
"Administrative Tools"
p
Diagnostics". The program starts up.
Next
.
is displayed.)
is displayed.)
Start
.
Windows NT

Advertisement

Table of Contents
loading

Table of Contents