Installing And Removing An Optional Interface Card; Installing An Interface Card - H3C LSW1SP4P0 User Manual

Installing and Removing an Optional
Interface Card
NOTE:
This section takes the LSW1SP4P0 interface card and the H3C
•
S5820X-28C switch to illustrate the module installation and
removal.
The installation tools are not shipped together with H3C's
•
Ethernet switches. You need to prepare the tools.
The following tools are needed for installation and removal:
Phillips screwdriver
•
ESD-preventive wrist strap
•

Installing an Interface Card

1. Put on an ESD-preventive wrist strap and make sure that the strap
is in good contact with your skin and is properly grounded.
2. Loosen the mounting screws of the blank panel on the expansion
slot of the switch's front panel with a Phillips screwdriver and
remove the blank panel, as shown in Figure
11
5.