Connecting The Ac Power Cord - H3C Magic BS200 GE Series Installation Manual

• Confirm that the types of the selected optical cable connectors and modules match.
• Install the optical module and the optical cables. Do not insert the optical cables directly to the
optical port.
To install the optical cables:
1. Wear an ESD wrist strap. Make sure the handle of the optical module flips up vertically and
locks in the top buckle. Pinch the sides of the optical module with your hands and slowly insert
the end without the handle into the optical slot.
2. Verify the Rx and Tx ports on the optical module and remove the protection cap on the optical
cable.
3. Plug the two LC-type connectors at one end of the cable into the Rx and Tx ports respectively.
Plug the two LC-type connectors at the other end of the fiber into the Tx and Rx ports of the
other device respectively.
4. Power on and verify that the LEDs on the panel are normal:
On - The link is present on the port.

Off - The link is not present. The sending port and the receiving port might be connected

wrong. Exchange the Rx and Tx ports on the optical cable.
WARNING!
Do not stare into the optical port and optical cable connectors to prevent the beam from hurting your
eyes.
Figure2-8 Install the optical module and optical cables.

Connecting the AC power cord

1. Wear an ESD wrist strap. Make sure it makes good skin contact and is reliably grounded.
2. Plug the end of the AC power cord of the switch with the socket into the power input connector
of the switch.
3. Connect the other end of the power cord to an external AC socket.
2-6