Avaya WLAN 2332 Installation Manual page 55

AP LED Appearance
Solid green
Alternating green and
amber
Solid amber
Blinking amber
Unlit
Note.
The 10/100 Ethernet ports on a WSS are configured as wired network ports by
default. You or the system administrator must change the port type for a WSS port directly
connected to an AP to activate the link. (See the Avaya WLAN 2300 Series—Security
Switch Installation and Basic Configuration Guide.)
Installing and connecting a Series 2332 Access Point 55
Meaning
For an AP's active link, all the following are
true:
• AP has booted.
• AP has received a valid configuration from
the WSS.
• Management link with an AP is operational.
• At least one radio is enabled or is in sentry
mode.
For an AP's secondary link, the link is present.
AP is booting with an image received from the
WSS. After the access point boots and receives
its configuration, this LED appearance persists
until a radio is enabled or is placed in sentry
mode.
PoE is on.
AP is unresponsive or there is a PoE problem.
PoE is off.
Avaya WLAN Series 2332 Access Point Installation Guide