Avaya WLAN 2332 Installation Manual page 37

1
Select an installation location that is centered over a T-bar in the ceiling.
2
Cut a hole as follows in the ceiling tile for the Cat-5 cable:
Place the mounting template over the area where you plan to install the AP.
a
Use the box cutter to cut along the line marking the opening for the port
b
connector.
Remove the mounting template and the material you cut from the ceiling panel.
c
3
Determine whether to install a T-bar clamp onto the ceiling T-bar:
●
If the T-bar width is 14.2 mm (9/16 inches), you need to install the 14.2-mm (9/16-inch) T-bar
clamp. Go to
●
If the T-bar width is 23.9 mm (15/16 inches), the universal mounting bracket fits directly onto the
T-bar. Go to
4
Install the 14.2-mm (9/16-inch) T-bar clamp onto the ceiling T-bar as shown in
Slide each half of the clamp onto the T-bar so that the clamp lip is fully on the
a
T-bar.
Slide the two halves of the clamp toward each other until the tabs are inserted
b
completely into the holes and the clamp fits snugly on the T-bar.
Figure 6. Step 4—Installing a T-bar Clamp
T-bar
5
Unlock the universal mounting bracket from the AP by inserting the 3-mm or 1/8-inch screwdriver into
the Unlock hole on the AP as shown in
Caution!
components, do not use excessive force when inserting a tool into the Unlock or
Lock hole.
Installing and connecting a Series 2332 Access Point 37
step 4.
step 5.
T-bar clamp halves
Figure
To avoid damage to the AP's lock mechanism or electronic
Avaya WLAN Series 2332 Access Point Installation Guide
Slide together
7.
Figure 6 on page 37.