Avaya WLAN 2332 Installation Manual page 53

8
Install the Kensington lock (optional).
Loop the Kensington lock's cable around an object that cannot be moved or
a
damaged by a person pulling on the cable.
Insert the key into the Kensington lock.
b
Insert the Kensington lock into the security slot on the AP.
c
Rotate the key right or left to secure the lock to the AP.
d
Pull on the lock to verify that it is secured to the AP.
e
Remove the key.
f
9
Place the AP on the bracket, making sure to remove any slack that occurs in the cable between the bracket
and the AP.
10 Lock the AP onto the bracket by inserting the 3-mm or 1/8-inch screwdriver into the Lock hole on the
access point as shown in
Warning!
device is fully locked onto the bracket before releasing it.
Figure 29. Step 9—Locking the Bracket
Lock
11 To ensure that the AP is fully locked onto the bracket, gently pull on the access point and attempt to rotate
it from side to side.
If the access point comes off the bracket, relock the device onto the bracket as described in
page 53.
12 If the other end of the Cat-5 cable is not already connected and the link activated, then go to
an AP to a WSS" on page
Installing and connecting a Series 2332 Access Point 53
Figure 29.
To prevent possible damage to the AP, make sure the
54. Otherwise, go to
Avaya WLAN Series 2332 Access Point Installation Guide
"Verifying AP health" on page
step 10 on
"Connecting
56.