Table of Contents
Advertisement
48 Installing and connecting a Series 2332 Access Point
Figure 23.
Step 3—Placing the Bracket on the Junction Box
Junction box
4
Pull the Cat-5 cable about 15 cm (about 6 inches) out of the junction box and through the port connector
opening to create enough slack to insert the cable into the port connector.
5
Insert the Cat-5 cable into the connector.
6
Install the Kensington lock (optional).
Loop the Kensington lock's cable around an object that cannot be moved or
a
damaged by a person pulling on the cable.
Insert the key into the Kensington lock.
b
Insert the Kensington lock into the security slot on the AP.
c
Rotate the key right or left to secure the lock to the AP.
d
Pull on the lock to verify that it is secured to the AP.
e
Remove the key.
f
7
Lift the AP into place on the universal mounting bracket.
Make sure the cable feeds properly into the junction box as you lift the device, and does not become
trapped between the access point and the bracket.
NN47250-307 (Version 02.02)
Port connector
opening
Advertisement
Table of Contents
