Table of Contents
Advertisement
50 Installing and connecting a Series 2332 Access Point
❍
Note.
holes indicated by the dashed lines in
these holes. They are not screw holes.
Remove the template.
c
2
Install the drywall anchor(s):
Insert a drywall anchor into each hole, up to the beginning of the threads on the
a
anchor.
Screw each anchor the rest of the way into its hole using a #2 Phillips-head
b
screwdriver.
Remove the screw from each anchor and save the screw(s) for
c
3
Unlock the universal mounting bracket from the AP by inserting the 3-mm or 1/8-inch screwdriver into
the Unlock hole on the AP as shown in
Caution!
components, do not use excessive force when inserting a tool into the Unlock or
Lock hole.
Figure 25.
Step 3—Unlocking the Bracket
NN47250-307 (Version 02.02)
If you plan to route the Cat-5 cable through a hole in the wall or ceiling, mark
the location of the center screw hole only. You cannot use the screw hole by
the port connector opening if you cut a hole for the opening.
Do not mark the four holes on the edges of the bracket. (These are the
To avoid damage to the AP's lock mechanism or electronic
Figure 27 on page
Figure 25 on page
50.
52.) The AP fits into
step 6 on page
51.
Advertisement
Table of Contents
