Avaya WLAN 2332 Installation Manual page 39

Figure 9. Step 7—Top View
Universal mounting
bracket
T-bar
Port connector
opening
(Viewed from above ceiling tiles, looking down.)
Properly align the bracket for mounting by placing the bracket so that its port
b
connector opening is to the left of the hole you cut for the cables.
Rotate the universal mounting bracket clockwise until the flanges snap into place
c
on the T-bar or clamp as shown in
Figure 10. Step 7—Bottom View
Port connector
opening
8
Pull the Cat-5 cable about 15 cm (about 6 inches) out of the hole in the ceiling tile and through the port
connector opening to create enough slack to insert the cable.
9
Insert the Cat-5 cable into the connector:
10 Install the Kensington lock (optional).
Loop the Kensington lock's cable around an object that cannot be moved or
a
damaged by a person pulling on the cable.
Installing and connecting a Series 2332 Access Point 39
Figure 10 on page
Universal mounting bracket
T-bar
Avaya WLAN Series 2332 Access Point Installation Guide
39.