Table of Contents
Advertisement
Figure 15.
Step 4—Unlocking the Bracket
5
Remove the bracket as shown in
Figure 16.
Step 5—Removing the Bracket
6
Install the universal mounting bracket as follows onto the T-bar clamp:
As shown in
a
clamp so that the two screw holes face downward and the two T-bar flanges face
upward and are adjacent to the T-bar edges.
Properly align the bracket for mounting by placing the bracket so that its port
b
connector opening is to the left of the hole you cut for the cables.
Rotate the universal mounting bracket clockwise until the flanges snap into place
c
on the T-bar clamp as shown in
Installing and connecting a Series 2332 Access Point 43
Figure 16 on page
Figure
17, place the universal mounting bracket against the T-bar
Figure 18 on page
Avaya WLAN Series 2332 Access Point Installation Guide
43.
44.
Advertisement
Table of Contents
