Cal Flame 2005 Spa Owner's Manual page 45

Table of Contents

Advertisement

Remote Control Operation
Eject/ DVD
TV/DVD
Auto Program
Skip/Search
Erase/Add
Channel Up
Menu
Enter
Return
Channel Down
Vol -
TV
Program
SubTitle
Stop
Pause/Replay
NEXT
PREV
Figure 49. Remote control
NOTE: These buttons will not affect the volume of wireless headphones or a wired RF modulator. When using
these devices, the volume must be adjusted with the headphone volume control or with your radios volume
control.
MENU Button
Press the MENU button. The MENU display appears. Use the Channel Up and Down buttons to select the
desired function, then press ENTER button to end the choice.
TV/VIDEO Button
Press this button to access the AUDIO/VIDEO input jacks, on the front and rear of the TV. As the button is
pressed, the on-screen display will cycle as follows:
TV
AV1
MUTE Button
Press this button to turn the TV sound off. Press again to restore sound to the previously set level. MUTE
may also be released by pressing the VOLUME +/-.
Erase/Add
When tuned to a channel press this button to store or erase the channel from memory. The stored channel
numbers are displayed in GREEN on the screen and the no stored channel numbers are in RED.
2005 Spa Owner's Manual
7/21/2005
TV/CATV
Power
Channel Pad
PRC/Sel
Mute
Display
Vol +
DVD
VCR
Angle
Audio
Play
REW
FF
AV2
AUX
Operating the Cal Flame Entertainment Center
TV Power
Press this button to turn on the set.
Press the button again to turn the set off.
Direct Access (0-9, 1--) Number Buttons
Use these buttons to select a channel. The channel number
chosen will be displayed on the screen for about four
seconds. To select channels 0-99, press two numbers. For
example, to select channel 8, press 0,8. To select above
100, press the 1-button, then the number buttons for the
last two digits of the channel. For example, to select
channel 115, press 1--, 1,5.
CHANNEL Up and Down
Use these buttons to select pre-programmed channels of
two select channels up or down.
VOLUME Up and Down
Use these buttons to raise or lower the volume level of the
Wired Headphones or External Speakers if installed. They
are also used to make adjustments in the picture mode.
Page 41

Advertisement

Table of Contents
loading

Table of Contents