Cal Flame 2005 Spa Owner's Manual page 33

Electronically Lighting the Grill and Infrared Burners
1. Open the hood.
2. Keep your face as far away from the burners as possible.
3. Rapidly rotate the burner knob counter clockwise past the light position to HIGH. You will hear a loud
click as the electronic lighter produces a spark.
4. Listen for the sound of the gas igniting. If the burner does not light on the first try, repeat immediately.
5. If the burner does not light after three attempts, turn the control knobs to the OFF position. Wait five
minutes until the gas clears before attempting to light it again.
6. Repeat the procedure or try the manual lighting procedure below.
7. Upon successful lighting, repeat the process on the other burners you wish to light.
8. To shut off the burners, rotate the knob and turn to OFF. It is normal to hear a popping sound when the
burners are turned off.
Manually Lighting the Grill and Infrared Burners
1. Open the hood.
2. If you have just attempted to light the burner, allow five minutes for any accumulated gas to dissipate.
3. Slide out the drip tray from the grill.
4. Keep your face as far away from the burners as possible.
5. Light and insert a long stem match, holding it near the burner ports.
6. Push in and turn the control knob just past the LIGHT position to HIGH.
7. Listen for the sound of the gas igniting. If the burner does not light after five seconds, turn the control
knobs to the OFF position. Wait five minutes until the gas clears before attempting to light it again.
8. If the burner does not light after several attempts see Troubleshooting Guide in the back of this manual.
Lighting the Main Burner with a Paper Match
Before proceeding with these instructions, familiarize yourself with the safety precautions in the first section of
this manual.
Ensure the lid is open before lighting the flame.
1. Set all barbecue grill control knobs to OFF and open the gas supply.
2. Remove the cooking grid and flame tamers from the burner you wish to light.
3. Insert the lighted match, placing the flame near the burner ports.
4. Press the control knob and turn it to the HIGH setting, releasing gas into the burner. The burner should light
immediately.
2005 Spa Owner's Manual
7/21/2005
Operating Your Barbecue
Page 29