Cylinder Headl Installed - Mercedes-Benz 201.024 Service Manual

Cylinder headl installed

Removal, installation
1 Put piston of the relevant cylinder on ignition
TDC.
Note
The respective pistons are in the ignition TDC
position, when the markings on vibration damper
shown in the adjacent drawing are beneath the
TDC pointer.
Marking
Piston at TDC on
cylinder
2 Removal and installation of oil pipe (67).
3 Remove and install the required rocker arm
bearing support (61) tightening torque 20 Nm.
Installation note
Before installing rocker arm bearing support
lubricate camshaft journals.
Install the rocker arm bearing support so that the
support area for the oil pipe points rearwards
and the code number is on the right (in the
direction of travel).
The ball sockets (55) must be installed in the
same position again.
05.0906 - 2503
I 180"
1 and 4 2 and 3
EXIT