Table of Contents
Advertisement
Turn the pressure pad (06) by hand to the right
sufficiently until it contacts the washer (57,
previous picture), and a clearly detectable
pressure point is reached.
Note
The pressure pad must contact the washer and
not the rocker arm.
3
Insert measuring pin adapter (04) in the
central bore of the pressure pad (06), set dial
gauge measuring pin on the measuring pin
adapter with 5 mm pretension (small pointer) and
attach the dial gauge to claw sleeve bracket
(arrow).
Position large dial gauge pointer on
zero by turning the dial gauge scale.
4
Turn pressure pad (06) slowly to the right
with a fork wrench (17 mm) on the hexagon until
a clearly detectable pressure point is reached.
Read off setting range (residual stroke) on dial
gauge. It must be 0.5 - 2.4 rnolp. In event of
smaller or larger residual stroke, correct
installation position of the hydraulic valve
clearance compensating element.
05 0906 - 214/7
EXIT
Hide quick links:
Advertisement
Table of Contents
