Table of Contents
Advertisement
4
Press in new small end bushing so that the
Press-fitting pressure 2500 N.
5
Hollow out small end bushing by turning or
reaming.
6
Dress side contact faces of conrod on the
surface plate.
Checking angles
7
Check angles of bearing bores with a conrod
tester.
8
Align conrod bearing bore to small end
bushing bore (parallelism).
twist of conrod bearing bore
9 Check axial
end bushing bore and correct, if
relative to small
necessary.
03.0905 - 3136
EXIT
2 7
Hide quick links:
Advertisement
Table of Contents
