Canon opture 10 Instruction Manual page 88

Recording to a VCR or Digital Video Device
!§.
You can copy your recordings by connecting the camcorder to a VCR or a digital video
device. If you connect a digital video device, you can copy recordings with virtually no
generation loss in image and sound quality.
•
When connecting a VCR:
o
Make sure that
"0"
is not displayed on the screen. If
"0"
is displayed, change
the setting ([IJ 70).
o
The quality of the edited tape will be slightly lower than that of the original.
When connecting a digital video device:
o
You can connect only one device to the camcorder with the
DV
cable.
o
Blank sections may be recorded as anomalous picture.
o
If the picture does not appear, reconnect the
DV
cable or turn the camcorder
off and back on again.
-
~,pJe"~~gs;Qcdj.ill~lQ1t'a';f)l"lt:"ii:f::c::~:::.::L":;""':f: . • . . : ,·.i::::·:fl;;":+"::~:::::::t:::8",,:.·'",:iif;::orr;"T,t:~0"::":·""';;.:;:,
I
"~
.
1. Connect the camcorder to the VCR.
See
Playing Back on
a
N Screen
([IJ 40).
2. Set the camcorder to PLAY (VCR) mode and load a recorded cassette.
3. Connected device: load a blank cassette and set the device to record
pause mode.
C)
..§ 4. locate the scene you wish to copy and pause playback shortly before
:E
the scene.
5. Play back the tape.
6. Connected device: Begin recording when the scene you wish to copy
appears. Stop recording when copying is complete.
7. Stop playback.
88