Canon opture 10 Instruction Manual page 144

-
- c
~ .2
o ...
•- III
.t::
E
'U ...
'U 0
<-
.=
144
List of Messages
Message Explanation
CD
SET THE TIME ZONE,
You have not set the time zone, date and time. This message 25
DATE AND TIME
appears each time you turn the power on until you set the
time zone, date and time.
CHANGE THE Battery pack is exhausted. Replace or charge the battery
16
BATTERY PACK
pack.
THE TAPE IS SET FOR Cassette is protected. Replace the cassette or change the
23
ERASURE PREVENTION position of the protect switch.
REMOVE THE Camcorder stopped operating to protect the tape. Unload 22
CASSETTE
and reload the cassette.
CHECK THE DV INPUT DV cable is not connected, or the connected digital device is
89
turned off.
CONDENSATION HAS Condensation has been detected in the camcorder. 148
BEEN DETECTED
TAPE END Tape reached the end. Rewind the tape or replace the
22
cassette.
CHECK THE CASSETTE You attempted to perform audio dubbing or AV insert on a
52
[REC MODE] tape recorded in a mode other than the SP mode.
CHECK THE CASSETTE You attempted to perform audio dubbing on a tape
97
[AUDIO MODE] recorded in 16-bit or 12-bit 4-channel sound.
CHECK THE CASSETTE You attempted to perform audio dubbing or AV insert on a
95
[BLANK] tape with a blank section.
HEADS DIRTY, USE Video heads are dirty. Clean the video heads. 148
CLEANING CASSETTE
COPYRIGHT PROTECTED You attempted to play back a copyright protected tape. 92
PLAYBACK IS RESTRICTED
COPYRIGHT You attempted to dub a copyright protected tape. May also 92
PROTECTED DUBBING appear when an anomalous signal is received during analog
RESTRlaED line-in recording, or during analog-digital conversion of a
copyright protected tape.