Canon opture 10 Instruction Manual page 100

Connecting to a Computer Using a DV (IEEE1394J Cable
E
You can transfer recordings to a computer equipped with a DV (IEEE1394) terminal or
IEEE1394 capture board (optional software required).
DV IN/OUT
terminal
o
Do not disconnect the DV cable, or turn off the camcorder or computer while
data is being transferred to the computer.
o
Operation may not work correctly depending on the software and the
specifications/settings of your computer.
o
We recommend powering the camcorder from a household power source
while it is connected to the computer.
o
Refer also to the instruction manual of the computer.
o
Optional software required. Refer also to the instruction manual of the
software.
o
For transferring recordings from a memory card to the computer using a USB
cable, see p. 135.
~
c:
.-i=i
:c
wO~,:~",E:I~QR,K?:SQ:,L,U:IIQ,~",::D::I:SKn:'W:ig,d!g,~S}:X2,U,5ie'5}
Windows XP users can use the software on the supplied DV NE1WORK SOLUTION
DISK to perform videoconference and file transfer over the Internet, or upload files
from the computer to the memory card and use the camcorder as card reader/writer.
The available functions depend upon the camcorder model and the networking
environment. For
details~
refer to the DV NE1WORK SOLUTION DISK Software
Instruction Manual.
-
o
Do not disconnect the DV cable, remove the memory card or turn off the
camcorder or computer while data is being transferred to the computer (while
the camcorder's card access indicator is flashing). Doing so may damage the
memory card's data.
o
The image files on your memory card and the image files saved on the hard
disk drive of your computer are your valuable, original data files. If you wish to
use image files on your computer, be sure to make copies of them first,
retaining the original.
100