Canon opture 10 Instruction Manual page 70

o
Low sound may be reduced together with the wind noise. We recommend
turning off the wind screen for normal recordings.
o
The wind screen function cannot be turned on/off during recording.
o
The wind screen function can also be used for audio dubbing (when [AUDIO
DUB.] is set to [MIC. IN] in the [AUDIO SET UP] submenu).
o
The wind screen function cannot be used when an external microphone is
connected to the MIC terminal or when the DM-SO Microphone is attached to
the advanced accessory shoe.
~~~Jigg,~JAljDQwiffl_~_$_~~~""_~~
You can use headphones to monitor the sound during recording.
. . When using headphones, make sure that
"0"
is displayed. If
"0"
is not displayed
. . change the setting following the procedure below.
Adjusting the Headphone Volume
..............................................................................................................................................................................................
CARD PLAY (VCR)
CARD CAMERA
CARD CAMERA
PLAY (VCR)
CAMERA
CAMERA
~~~~
IVCR SET UP
I~IAV/PHONES
.... AV
Open the menu and select [VCR SET UP]. Select [AV/PHONES], set it to [AV]
or [PHONES
0 ]
and close the menu.
Switching the AV/Headphones Terminal
..........................................................................................................................................................................................................
-
~~~~
I
AUD
I 0
SET UP
I~I
OVOLUME· ••••
-a<l1IllIIlJ
Open the menu and select [AUDIO SET UP]. Select [
0
VOLUME]. adjust
the volume with the selector dial and close the menu.
You can turn off the
volume
completely by turning the selector dial down until [OFF]
appears. Turn the selector dial up to increase the volume again.
70