Canon opture 10 Instruction Manual page 226

D
o
Make sure the camcorder is being powered using the power adapter
before connecting it to a computer.
o
Be sure to install the DIGITAL VIDEO SOLUTION DISK before you
connect the camcorder to the computer.
o
Connect the USB cable directly to one of the compute(s main USB
ports. The interface may not function correctly if the camcorder is
connected via a USB hub.
o
The connection may not operate correctly if you are using other USB
devices/ excluding USB mice or keyboards/ at the same time. If this
occurs/ disconnect the other devices from the computer and try
reconnecting the camcorder.
o
Do not connect two or more camcorders to the same computer via
the USB interface. The connections may not operate correctly.
o
Never allow the computer to go into standby (sleep) mode
while a camcorder is connected via the USB interface. If it does
happen, never disconnect the USB cable. Try to awaken the
computer with the camcorder in the connected state. Some
computers will not awaken properly if you disconnect the
camcorder while they are in standby mode. Please refer to your
computer manual for instructions regarding its standby mode.
1.
Insert a memory card containing still images/movies into the
camcorder.
2.
Connect the power adapter to the camcorder.
3.
Turn the POWER switch to PLAY (VCR) and move the TAPE/
CARD switch to CARD.
Wait until the card access indicator stops flashing.
4.
Attach the supplied USB cable to the computer's USB port
and the camcorder's USB Terminal.
• You do not need to turn off the computer for this procedure.
• Refer to your computer manual for the location of the compute(s USB ports.
• See your camcorder instruction manual for connecting instructions.
USB Terminal
USB Cable
on the Camcorder ~ ~
~~
I
~
"
B
-+-
Camcorder End computei_E_n_d
-~_----:..._--
USB Port on
the Computer
64