Port; Turning On / Off The Power - EverFocus eZ.HD ECOR HD 16X1 User Manual

2.3.3 RS-485 Port
The RS-485 port, located on the rear panel of the DVR, can be used to connect to an RS-485
keyboard for controlling PTZ cameras or simply connect to a PTZ camera or connect to a POS
device. For details on the RS-485 configurations on the DVR, please refer to 6.9.5 I/O Control.
EKB500 Keyboard

2.4 Turning On / Off the Power

Before powering on the DVR, please make sure the internal HDDs have been installed properly.
Once you have completed the basic cable connections, you are ready to turn on the DVR.
To turn on the power, connect the supplied Power Cord to the power outlet and turn on the
Power Switch. All of the LED indicators on the front panel will light up. The DVR will automatically
run an internal process, when the process is complete, the LED indicators will turn off, and the
POWER LED will remain light up in green. And then you can start operating the DVR.
To turn off the power, please go to OSD Root Menu > System Setting > Miscellaneous setting
page, and click Shutdown (refer to 6.9.7 Miscellaneous). After the message pops up as below,
you can now turn the Power Switch to the "Off" position.
Rear View
RS-485 Port
RS-485 Cable
17
Coaxial Cable
Analog PTZ Camera
1~16
ECOR HD 16X1 DVR