Rear Panel - EverFocus eZ.HD ECOR HD 16X1 User Manual

1.6 Rear Panel

1
2
7
No. Name
1 Alarm Input /Out
2 RS-485 Port
Audio Output
3
(RCA)
Call Monitor Port
4
(CVBS/BNC)
5 eSATA Port
6 Power Switch
Audio Input
7
(RCA)
8 Video Input
Main Monitor
9
Port (HDMI)
3 4
Description
Connects up to 16 alarm inputs, and to 2 alarm output devices. You can
also connect to the radio-controlled clock for time synchronization.
Please refer to 2.3.2 Alarm I/O.
Connects to the RS-485 device (EKB500) or PTZ camera.
Connects to the audio output devices, such as speakers. Note that the
speaker with a (built-in) amplifier and external power supply are
required.
Connects to the Call monitor using a CVBS cable. Please refer to 2.3.1
Monitor Connection.
Connects to an external eSATA storage device, please set up an RAID
array of the eSATA device before using.
Press to turn on or off the power.
Connects to the audio input devices such as microphones. Note that
the microphone with a (built-in) amplifier and external power supply is
required.
Connect analog HD cameras using coaxial cables.
Note:
1. You must connect a camera to the channel 1 of the DVR so that it
can automatically detect the video signal type (NTSC or PAL).
2. The ECOR HD 16X1 DVR has 16 video inputs which are all
compatible with both HD (EverFocus eZ.HD series camera) and SD
cameras*; however, the 16 video inputs are divided into 8 pairs as
the figure above. Therefore, when connecting HD and SD cameras to
the DVR, you should connect either type of the above cameras to the
SAME pair video inputs (Please see the example on the next page).
* The eZ.HD series DVR doesn't support HD-TVI / HD-CVI cameras.
Connects to the Main monitor using a HDMI cable. Please refer to 2.3.1
Monitor Connection.
8
8
ECOR HD 16X1 DVR
5 6
9 10 11 12 13