Display; Sequence - EverFocus eZ.HD ECOR HD 16X1 User Manual

4.4 Display

You can display system and camera status on the live view screen. Follow the steps below:
1. Click the Display button
button to choose the desired display mode:
2. The following icons will be displayed at the top-left side of each camera stream to show each camera's status.
Recording
Alarm
3. The following icons will be displayed at the bottom of the monitor to show the system status.
Audio On
No network 1
4. There are four display modes, and you can click the Display button to change the display mode: (1) Display both
the camera and system status icons. (2) Display only the camera status icons. (3) Display only the system status
icons. (4) Hide both the camera and system status icons.

4.5 Sequence

The sequence function is used to display each channel in sequence mode. To enable this function:
By Mouse: Click the Sequence button
channel at a time in full screen. The channels will be displayed in the sequence and for the amount of time as
configured in the System > Display Setting > M/T SEQ submenu. The default setting is channels 1~16 / 1~8 / 1~4
with a dwell time of 3 seconds each – repeated. Please refer to 6.6.2 M/T SEQ for detailed information.
By Front Panel: Press the "SEQ" button on the front panel to enter the sequential switching mode.
on the OSD Root Menu to display the system and camera status. Click the
Playback Fast forward
Motion Video loss
Audio Off
Sequence HDD failure
to enter the sequential switching mode. The DVR will display one
Fast backward
Uninstall
Alarm Motion
HD temp. too high
44
ECOR HD 16X1 DVR
Back pause
Audio On
Video loss
Event