System Setting; Date / Time - EverFocus eZ.HD ECOR HD 16X1 User Manual

6.9 System Setting

You can configure the general settings for the DVR in this menu.
6.9.1

Date / Time

You can set up the date and time for the DVR.
Note: Clicking Save at this page will disable the Daylight Saving function if this function has
been enabled and a notice message will pop up as "Please enable the Daylight Saving Time
again if the function is needed". Therefore, after setting up the time at this page, you need to
go to Daylight Saving page to reset and enable the daylight saving time if the function is
needed. Please refer to 6.9.2 Daylight Saving for detailed information.
Date: Click to bring up the on-screen keyboard to set up the date.
Time: Click to bring up the on-screen clock to set up the time.
Date Format: Select a date format from the drop-down list.
Time Format: Select a time format from the drop-down list.
Time Zone: Select a time zone for the DVR to adjust to when updating from the time server.
NTP: Select Disable / Enable for NTP time synchronization.
NTP Server: Displays the time server address that the DVR uses for time synchronization. Requires operating
network configuration and WAN or LAN access to a compatible NTP server. The default NTP address is the NTP
server in Taiwan. To find a compatible NTP address of the DVR's physical location, follow the steps below:
a. Use a computer connected to the Network.
b. Click Start > Run > type "command" and then click OK.
c. In the DOS Prompt, type "ping pool.ntp.org" to find out the IP address of an NTP Server.
109
ECOR HD 16X1 DVR