Table of Contents
Advertisement
2.3.3 RS-485 Port
The RS-485 port, located on the rear panel of the DVR, can be used to connect to an RS-485
keyboard for controlling PTZ cameras or simply connect to a PTZ camera or connect to a POS
device.
Note: EverFocus FHD series DVR supports the eZ.Controller function, which enables users to
control PTZ camera from DVR using only a coaxial cable without the need of a RS-485 cable
between the PTZ camera and the DVR (see 1.2 eZ. Controller Function Description).
2.4
Turning On / Off the Power
Before powering on the DVR, please make sure the internal HDDs have been installed properly.
Once you have completed the basic cable connections, you are ready to turn on the DVR.
To turn on the power, connect the supplied Power Cord to the power outlet and turn on the
Power Switch. All of the LED indicators on the front panel will light up. The DVR will automatically
run an internal process, when the process is complete, the LED indicators will turn off, and the
POWER LED will remain light up in green. And then you can start operating the DVR.
To turn off the power, please go to OSD Root Menu > System Setting > Miscellaneous setting page,
and click Shutdown (refer to 6.9.7 Miscellaneous). After the message pops up as below, you can
now turn the Power Switch to the "Off" position.
Rear View
Coaxial Cable
RS-485 Cable
PTZ Camera 1~16
19
PARAGON FHD 16x4
RS-485 Port
EKB500 Keyboard
Advertisement
Table of Contents
