Port; Turning On / Off The Power - EverFocus Paragon960 User Manual

PARAGON960 x4 32CH
2.3.4 RS-485 Port
The RS-485 port, located on the rear panel of the DVR, can be used to connect to an RS-485
keyboard, such as EverFocus' EKB500, for controlling PTZ cameras. For details on the RS-485
configurations on the DVR, please refer to 6.9.5 I/O Control.
Rear View
RS-485 Port
EKB500
RS-485
RJ-45 Cable
PTZ Camera 1~32
Connector Box
Figure 2-34
2.3.5 RS-232 Port
The RS-232 port, located on the rear panel of the DVR, can be used to connect to an RS-232 data
input device such as POS system. The RS-232 port of the PARAGON960 x4 32CH is a 9 pin D-Sub
socket. For details on the RS-232 configurations on the DVR, please refer to 6.9.5 I/O Control.
2.4

Turning On / Off the Power

Before powering on the DVR, please make sure the internal HDDs have been installed properly.
Once you have completed the basic cable connections, you are ready to turn on the DVR.
To turn on the power, connect the supplied Power Cord to the power outlet and turn on the Power
Switch. All of the LED indicators on the front panel will light up. The DVR will automatically run an
internal process, when the process is complete, the LED indicators will turn off, and the POWER LED
will remain light up in green. And then you can start operating the DVR.
To turn off the power, please go to OSD Root Menu > System Setting > Miscellaneous setting page, and
click Shutdown (refer to 6.9.7 Miscellaneous). After the message pops up as below, you can now turn
the Power Switch to the "Off" position.
Figure 2-35
24