ZyXEL Communications P-334WT User Manual page 97

Table 33 Wireless: 802.1x and Static WEP
LABEL
Key 1 to Key 4
ReAuthentication
Timer (in seconds)
Idle Timeout
Authentication Server
IP Address
Port Number
Shared Secret
Accounting Server
Active
IP Address
Port Number
Shared Secret
Apply
Reset
Chapter 4 Wireless LAN
DESCRIPTION
The WEP keys are used to encrypt data. Both the Prestige and the wireless
stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
If you chose 256-bit WEP, then enter 29 ASCII characters or 58 hexadecimal
characters ("0-9", "A-F").
You must configure at least one key, only one key can be activated at any one
time. The default key is key 1.
Specify how often wireless stations have to reenter usernames and passwords in
order to stay connected. Enter a time interval between 10 and 9999 seconds. The
default time interval is 1800 seconds (30 minutes).
Note: If wireless station authentication is done using a RADIUS
server, the reauthentication timer on the RADIUS server has
priority.
The Prestige automatically disconnects a wireless station from the wired network
after a period of inactivity. The wireless station needs to enter the username and
password again before access to the wired network is allowed. The default time
interval is 3600 seconds (or 1 hour).
Enter the IP address of the external authentication server in dotted decimal
notation.
Enter the port number of the external authentication server. The default port
number is 1812.
You need not change this value unless your network administrator instructs you
to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external authentication server and the Prestige.
The key must be the same on the external authentication server and your
Prestige. The key is not sent over the network.
Select Yes from the drop down list box to enable user accounting through an
external authentication server.
Enter the IP address of the external accounting server in dotted decimal notation.
Enter the port number of the external accounting server. The default port number
is 1813.
You need not change this value unless your network administrator instructs you
to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external accounting server and the Prestige.
The key must be the same on the external accounting server and your Prestige.
The key is not sent over the network.
Click Apply to save your changes back to the Prestige.
Click Reset to reload the previous configuration for this screen.
P-334WT User's Guide
97