ZyXEL Communications P-334WT User Manual page 379

Table 156 Menu 27.1 IPSec Summary
FIELD
Key Mgt
Remote Addr
Start
Remote Addr
End/Mask
Secure GW
Addr
Select
Command
Select Rule
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
Chapter 38 VPN/IPSec Setup
This field displays the SA's type of key management, (IKE or Manual).
When the Addr Type field in Menu 27.1.1 IPSec Setup is configured to Single, this is a
static IP address on the network behind the remote IPSec router.
When the Addr Type field in Menu 27.1.1 IPSec Setup is configured to Range, this is
the beginning (static) IP address, in a range of computers on the network behind the
remote IPSec router.
When the Addr Type field in Menu 27.1.1 IPSec Setup is configured to SUBNET, this
is a static IP address on the network behind the remote IPSec router.
This field displays N/A when you configure the Secure Gateway Addr field in SMT
27.1.1 to 0.0.0.0.
When the Addr Type field in Menu 27.1.1 IPSec Setup is configured to Single, this is
the same (static) IP address as in the Remote Addr Start field.
When the Addr Type field in Menu 27.1.1 IPSec Setup is configured to Range, this is
the end (static) IP address, in a range of computers on the network behind the remote
IPSec router.
When the Addr Type field in Menu 27.1.1 IPSec Setup is configured to SUBNET, this
is a subnet mask on the network behind the remote IPSec router.
This field displays N/A when you configure the Secure Gateway Address field in SMT
27.1.1 to 0.0.0.0.
This is the WAN IP address or the domain name (up to the first 15 characters are
displayed) of the IPSec router with which you are making the VPN connection. This field
displays 0.0.0.0 when you configure the Secure Gateway Address field in SMT 27.1.1
to 0.0.0.0.
Press [SPACE BAR] to choose from None, Edit, Delete, Go To Rule, Next Page or
Previous Page and then press [ENTER]. You must select a rule in the next field when
you choose the Edit, Delete or Go To commands.
Select None and then press [ENTER] to go to the "Press ENTER to Confirm..." prompt.
Use Edit to create or edit a rule. Use Delete to remove a rule. To edit or delete a rule,
first make sure you are on the correct page. When a VPN rule is deleted, subsequent
rules do not move up in the page list.
Use Go To Rule to view the page where your desired rule is listed.
Select Next Page or Previous Page to view the next or previous page of rules
(respectively).
Type the VPN rule index number you wish to edit or delete and then press [ENTER].
P-334WT User's Guide
DESCRIPTION
379