Ordering Your Rules; Figure 175 Menu 15.1.1 First Set; Table 132 Menu 15.1.1 First Set - ZyXEL Communications P-334WT User Manual

Figure 175 Menu 15.1.1 First Set

Menu 15.1.1 - Address Mapping Rules
Set Name= NAT_SET
Idx Local Start IP
--- --------------- -------------- --------------- ---------------
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Note: If the Set Name field is left blank, the entire set will be deleted.
The Type, Local and Global Start/End IPs are configured in menu 15.1.1.1
(described later) and the values are displayed here.

28.3.1.2 Ordering Your Rules

Ordering your rules is important because the Prestige applies the rules in the order that you
specify. When a rule matches the current packet, the Prestige takes the corresponding action
and the remaining rules are ignored. If there are any empty rules before your new configured
rule, your configured rule will be pushed up by that number of empty rules. For example, if
you have already configured rules 1 to 6 in your current set and now you configure rule
number 9. In the set summary screen, the new rule will be rule 7, not 9.
Now if you delete rule 4, rules 5 to 7 will be pushed up by 1 rule, so as old rule 5 becomes rule
4, old rule 6 becomes rule 5 and old rule 7 becomes rule 6.

Table 132 Menu 15.1.1 First Set

FIELD
Set Name
Action
Select Rule
Chapter 28 Network Address Translation (NAT)
Local End IP
Action= Edit
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Enter a name for this set of rules. This is a required field. If this field is left blank, the
entire set will be deleted.
The default is Edit. Edit means you want to edit a selected rule (see the following
field). Insert Before means to insert a rule before the rule selected. The rules after the
selected rule will then be moved down by one rule. Delete means to delete the
selected rule and then all the rules after the selected one will be advanced one rule.
None disables the Select Rule item.
When you choose Edit, Insert Before or Delete in the previous field the cursor jumps
to this field to allow you to select the rule to apply the action in question.
Global Start IP Global End IP
Select Rule=
P-334WT User's Guide
Type
------
307