Daikin G-Series Service Manual page 51

SiBE12-933_A
1.1.3 FTXG25/35E, CTXG50E, ATXG25-50E
Connectors PCB (1) (Control PCB)
1) S1
2) S21
3) S32
4) S36
5) S41
6) S46
7) S49
8) S51
PCB (2) (Signal Receiver PCB)
1) S47
PCB (3) (INTELLIGENT EYE sensor PCB)
1) S36
Note: Other designations
PCB (1) (Control PCB)
1) V1
2) JA
3) FU1 (F1U)
4) LED A
PCB (2) (Signal Receiver PCB)
1) SW1 (S1W)
2) LED2
3) LED3
4) LED4
5) RTH1 (R2T)
Printed Circuit Board Connector Wiring Diagram
Connector for fan motor
Connector for centralized control (HA)
Connector for heat exchanger thermistor
Connector for INTELLIGENT EYE sensor PCB
Connector for swing motor
Connector for signal receiver PCB
Connector for reduction motor (front panel mechanism)
Connector for front panel limit switch
Connector for control PCB
Connector for control PCB
Varistor
Address setting jumper
JB Fan speed setting when compressor is OFF on thermostat
JC Power failure recovery function (auto-restart)
∗
Refer to page 255 for detail.
Fuse (3.15A)
LED for service monitor (green)
Forced cooling operation ON / OFF switch
LED for INTELLIGENT EYE (green)
LED for timer (yellow)
LED for operation (green)
Room temperature thermistor
Printed Circuit Board Connector Wiring Diagram
41