Daikin G-Series Service Manual page 118

Instruction
To start COMFORT AIRFLOW operation
3. Press "COMFORT AIRFLOW button".
• The flap position will change, preventing air from blowing directly on the occupants of the room.
• "
• Airflow rate is set to "AUTO".
<COOL/DRY> The flap will go up.
<HEAT> The flap will go down.
To cancel COMFORT AIRFLOW operation
4. Press "COMFORT AIRFLOW button" again.
• The flaps will return to the memory position from before COMFORT AIRFLOW mode.
• "
Notes on COMFORT AIRFLOW operation
• POWERFUL operation and COMFORT AIRFLOW operation cannot be used at the same time.
Priority is given to POWERFUL operation.
Notes on flaps and louvers angles
• When "SWING button" is selected, the flaps
swinging range depends on the operation
mode. (See the figure.)
ATTENTION
• Always use a remote controller to adjust the
flaps angle. If you attempt to move it forcibly
with hand when it is swinging, the mechanism
may be broken.
• Be careful when adjusting the louvers. Inside
the air outlet, a fan is rotating at a high speed.
• If the air conditioner is operated in cooling or
dry mode with the flap kept stopped in the
downward direction, the flap will automatically
start operating in approximately an hour in
order to prevent dew condensation.
108
" is displayed on the LCD.
" disappears from the LCD.
In DRY mode or COOL mode
Stop operation
0°
COMFORT AIRFLOW
5°
Upper limit (SWING)
Lower limit (SWING)
In HEAT mode
Stop operation
0°
15°
Upper limit (SWING)
Lower limit (SWING)
COMFORT AIRFLOW
In FAN mode
Stop operation
0°
5°
Upper limit (SWING)
Lower limit (SWING)
SiBE12-933_A
45°
50°
45°
45°
Operation Manual