Printing - Ricoh D096 Service Manual

4.11.1 PRINTING

Make sure the paper is installed correctly in each paper tray before you start these
adjustments.
Use the Trimming Area Pattern (SP 5902, No.10) to print the test pattern for the
printing adjustments below.
Set SP 5902 to 0 again after you complete these printing adjustments.
- Registration - Leading Edge/Side-to-Side -
1. Check the leading edge registration for each paper feed station, and adjust each of
these registrations using SP 1001.
2. Check the side-to-side registration for each paper feed station, and adjust these
registrations using SP 1002.
Tray
All Trays
By-pass feed
1st tray
By-pass feed
A: Leading Edge Registration
B: Side-to-side Registration
- Blank Margin -
SM
Copy Adjustments Printing/Scanning
SP mode
SP 1001 1
SP 1001 2
SP 1002 1
SP 1002 5
4-59
Specification
2 ± 1.5 mm
D096