Ricoh D096 Service Manual page 134

Using SP Modes
5. Select "Execute." The messages "Execute?" followed by "Cancel" and "Execute"
shows.
6. Select "Execute."
7. When the program has ended normally, the message "Completed" shows. If the
program has ended abnormally, an error message shows.
8. Press the cancel key.
9. Turn the main switch off and on.
10. Download the NVRAM data from a flash memory card (
Upload/Download (SP 5824/5825))
- Without Flash Memory Card -
1. Print out all SMC data lists (
2. Select SP 5-801.
3. Press the OK key.
4. Select "Execute." The messages "Execute?" followed by "Cancel" and "Execute"
show.
5. Select "Execute."
6. When the program has ended normally, the message "Completed" is displayed. If the
program has ended abnormally, an error message shows.
7. Turn the main switch off and on.
8. Adjust the printer and scanner registration and magnification (
Adjustments Printing/Scanning").
9. Refer to the SMC lists, and enter any values that differ from the factory settings.
Double-check the values for SP 4901.
10. Adjust the standard white level (SP 4428).
11. Initialize the TD sensor (SP 2214).
12. Check the copy quality and the paper path.
D096
SMC Print (SP 5990)).
5-6
NVRAM Data
p.4-58 "Copy
SM