Ricoh D096 Service Manual page 210

SP Mode Tables
Paper Feed Timing
1003*
Adjusts the amount of buckle the paper feed clutch applies to the paper after
the registration sensor is activated. A higher setting applies greater buckling.
1003 1 1st tray
1003 4 By-pass feed
1007 Display By-pass
1007 1 Display By-pass
Fusing Idling
This program decides the action of the Fusing Drive Release Mechanism.
When you select "1," the contact/release control is disabled and the drive
1103*
power is always transmitted to the fusing unit. As a result, the machine takes
a longer time to warm up the fusing unit. Use SP 1103 1 if fusing quality is low
even when the room temperature is not very low.
1103 1 Fusing Idling
Fusing Temperature Adjustment
1105*
Adjusts the target fusing temperature. "Center" indicates the center of the
roller; "End" indicates the front and rear ends.
1105 1 Warm Up-Center
1105 2 Warm Up-End
1105 3 Standby-Center
1105 4 Standby-End
1105 5 Copying-Center
1105 6 Copying-End
D096
[0 to 10 / 5 / 1 mm/step]
[0 to 10 / 6 / 1 mm/step]
Displays the by-pass paper width switch output.
[0 = No / 1 = Yes]
[140 to 180 / 160 / 1°C/step]
[140 to 170 / 155 / 1°C/step]
[140 to 165 / 150 / 1°C/step]
[140 to 185 / 160 / 1°C/step]
4-2 SM Appendix