Ricoh D096 Service Manual page 214

SP Mode Tables
Right side
2101 4
Adjusts the right edge erase margin. The rear right edge is this value plus 0.3
mm.
2201* Development Bias Adjustment
Printing
Adjusts the voltage applied to the development roller when printing. This can
2201 1
be adjusted as a temporary measure if faint copies are being produced due
to an aging drum.
ID sensor pattern
Adjusts the voltage applied to the development roller when generating the ID
2201 2
sensor pattern. The actual voltage applied is this setting plus the value of SP
2201 1. The setting affects ID sensor pattern density, which in turn affects the
toner supply.
Outputs after Near End
2213*
[0 = 50 pages / 1 = 20 pages]
Sets the number of copy/print pages that can be made after toner near-end
2213 1
has been detected. Reduce the number of pages if the user normally makes
copies with a high image ratio.
Developer Initialization
2214
Initializes both the TD sensor toner supply target voltage and the TD sensor
2214 1
gain value. Carry this out after replacing the developer or the TD sensor.
D096
[0.0 to 9.0 / 2.0 / 0.1 mm/step] (
Printing/Scanning)
Specification: 2 +2.5/–1.5 mm
[–1500 to –200 / –650 / 1 V/step]
[–2 = LL (220 V) / -1 = L (260 V) / 0 = N (300 V) /
1 = H (340 V) / 2 = HH (380 V)]
4-6
Copy Adjustments
SM Appendix