Free Run - Ricoh D096 Service Manual

FREE RUN

2.9 FREE RUN
You can use DIP switch 100 (on the DF control board) to carry out a one-sided free
run.
Mode\Bits
Normal
FR with paper
Feed/Transport Motor Test
Feed Solenoid Test
Feed Clutch Test
Stamp Solenoid Test
Special I/F Test
FR without paper
Transport Motor Test
Procedure
1. Set bit 1 and/or bit 2 on SW100 (on the DF control board) to ON.
2. Set originals on the original table.
3. The free run starts automatically after about 2 seconds.
4. To stop the run, set SW100 bits 1 and 2 back to OFF. To ensure that the
system correctly resets, turn power off and then back on.
Free Run Process
1. Set originals on the DF table.
2. The first original sheet feeds into the DF.
3. The sensor detects the original.
4. The DF outputs the original to the exit tray.
5. Steps 2 through 4 repeat for each subsequent original sheet. When all
originals have been fed, the DF stops and waits for more.
B813
Bit0 Bit1
Off Off
On Off
On On
Off Off
On Off
Off On
Off Off
On Off
On On
14
Bit2 Bit3
Off Off
Off Off
Off Off
On Off
On Off
On Off
Off On
Off On
Off On
FR: Free run
SM