Continuous Scan - Kyocera TASKalfa 2550ci Operation Manual

Continuous Scan

When the multi-page originals cannot be placed in the document processor at one time, the originals can be
scanned in separate batches and then sent as one job. With this function, originals can be scanned one after
another until you press [Finish Scan].
Any of the following settings can be changed during scanning.
• Original Size
• Original Orientation
• 2-sided/Book Original
• Density
• Original Image
• Scan Resolution
• Color Selection
• Sending Size
• Zoom
• Border Erase
• Background Density Adj.
• Prevent Bleed-thru
• FAX TX Resolution (For details, refer to Fax System (W) Operation Guide.)
The procedure for using continuous scanning when sending scanned images is explained below.

Continuous Scan

Scan a large number of originals
in separate batches and then produce
as one job.
*Settings can be changed during scanning.
:
Original A4
Off
Zoom : 100%
:
Send A4
Preview
Add Shortcut
Status
1
2
3
Destination
4
On
Cancel OK
12/12/2011 10:10
5
6
7
6-23
Press the Send key.
Press [Advanced Setup] and then [Continuous
Scan].
Press [On]. Continuous Scan is selected.
Press [OK].
Specify the destination.
Place the original, and press the Start key.
When the scanning is completed, change the
settings as necessary.
Place the next original, and press the Start key. Scan
the remaining originals by the same procedure.
When you have scanned all the originals, press
[Finish Scan] to start sending.
Sending Functions
6