Kyocera TASKalfa 2550ci Operation Manual page 459

Symptom
Printouts are
wrinkled.
Printouts are curled.
Cannot print.
Cannot print with USB
memory.
USB memory not
recognized.
Dirt on the top edge
or back of the paper.
Part of the image is
periodically faint or
shows white lines.
Checkpoints
—
Is the paper damp?
—
Is the paper damp?
Is the machine plugged in?
Is the machine powered on?
Are the printer cable and
network cable connected?
Was the machine powered
on before the printer cable
was connected?
Is the print job paused?
Is the USB host blocked?
—
Check the paper chute and
the ramp.
—
—
—
—
12-5
Corrective Actions
Turn the orientation 180 degrees
around in which the paper is
positioned.
Replace the paper with new paper.
Turn the orientation 180 degrees
around in which the paper is
positioned.
Replace the paper with new paper.
Plug the power cord into an AC
outlet.
Turn on the main power switch.
Connect the correct printer cable
and network cable securely.
Power on the machine after
connecting the printer cable.
Resume printing.
Select [Unblock] in the USB host
settings.
Check that the USB memory is
securely plugged into the machine.
Open the right cover and check for
toner on the paper ramp inside the
paper transfer unit. Clean the
paper ramp using a soft, dry, lint-
free cloth.
Open and then close the right
cover.
Run [Drum Refresh].
Run [Developer Refresh].
Contact your service
representative.
Troubleshooting
Reference
Page
xxxviii
2-29
2-32
2-29
xxxviii
2-29
2-32
2-29
2-6
2-7
2-3
2-3
8-3
9-107
—
—
12
—
9-68
9-74
—