Table of Contents
Advertisement
Setting Communications Parameters
Host
1. Start the Communications program on the host PC.
2. Set up the host communication parameters (these parameters must match the
terminal's parameters). At the DOS prompt on the host, enter:
Typical parameters are:
Terminal
1. Boot the terminal to Command Mode (refer to
for the appropriate key sequence).
2. Select the Memory Transfer function from the Command Mode menu. Use
<UpArrow> or <DownArrow> to scroll through the command mode options until
Memory Transfer is displayed, and press <Enter>.
3. Select the range of memory to transfer by pressing the first letter of the desired
range (All, Range, or None), or use the <UpArrow> or <DownArrow> and press
<Enter>.
If you select All, the program skips to the range verification screen (step 7).
If you select Range, the screen displays:
4. Specify a range of RAM by setting the Start and End addresses.
•
Use <RightArrow> and <LeftArrow> to move the cursor to the digit to be
changed
•
Use <UpArrow> and <DownArrow> to change the values.
RCVHEX <filename.hex>
<baud rate> <comport#>
38400 bps
7 bit data
Odd parity
Xon/Xoff flow control
RAM
Use Arrow Keys
Start
End
00000
9FFFF
Error Recovery and Troubleshooting
Chapter 4, Operating the PDT 3100
5-13
Advertisement
Table of Contents
