Downloading Over The Network: Bootp (Default); Initiating Network Connection - Symbol PDT 3100 Series Product Reference Manual

Downloading Over the Network: BOOTP (Default)

Initiating Network Connection

1. Cold boot the terminal.
Note: Verify that terminal is OFF before cold booting.
a. Press and hold <A+B+D>.
b. Press and release <PWR>.
c. Release <A+B+D>.
The terminal boots DR-DOS and loads the radio driver while displaying a series of
boot messages.
2. Enter a new ESS Id, obtained from the Network Administrator, in the Configurator.
Note: This process is only required on the first-time, out-of-box network
connection.
On first boot, the Configurator screen appears:
3. Enter the new ESS Id:
a. Use the <UpArrow> and <DownArrow> to cursor to ESS Id.
b. The default ESS Id appears in ASCII format. Backspace over the existing value,
type a new value, and press <ENTER>.
c. If you are using a BOOTP or DHCP server, cold boot the terminal and proceed
to Unsuccessful Association with AP
CONFIGURATOR X.XX
View Config Parameters
ESS ID
Boot Mode
.
.
.
↑
, Clear, Enter
on page 3-8.
Spectrum24® RF Setup
3-7