Downloading Over The Network: Dhcp; Downloading Over The Network: Neither Bootp Or Dhcp - Symbol PDT 3100 Series Product Reference Manual

Downloading Over the Network: DHCP

To use the DHCP protocol, you must edit NET.CFG and rebuild the HEX file before initiating
the network connection.
1. Edit NET.CFG (see
DHCP parameter line:
2. Save the new NET.CFG on the network host in the \LWPnnn\KIT directory.
3. Working from the \LWPnnn\KIT directory, rebuild the HEX file. Use the
command:
which builds a LWPNFL.HEX file in the KIT subdirectory.
4. Download the new HEX file. Refer to the Series 3000 ADK.
5. Proceed with the network connection as described in
on page 3-7.

Downloading Over the Network: Neither BOOTP or DHCP

If a BOOTP or DHCP server is not used, the information these servers provide must be
obtained in other ways (e.g., you must enter the IP address manually using CFG24).
1. Edit NET.CFG (refer to
noboot parameter:
2. Save the NET.CFG file, build and download a new HEX file, and connect to the
network as described in
Editing NET.CFG on page 3-5). Add the section header and
Spectrum24 Control
DHCP
USRCFG @LWPNFL
Editing NET.CFG
Spectrum24 control
Noboot

Downloading Over the Network: DHCP

Spectrum24® RF Setup
Initiating Network Connection
on page 3-5). Add a control section and
on page 3-11.
3-11