Symbol PDT 3100 Series Product Reference Manual page 39

To cancel and set up a new ESS Id (obtained from the Network Administrator):
1. Press <Ctrl+C> to end the attempt. The terminal displays the message:
2. Type Y to exit to the DOS prompt (D:).
3. At the DOS prompt, type CFG24 on the PDT 3142, or CFG11 on the PDT 3146, and
press <ENTER> to initiate the Configurator:
4. Use the <UpArrow> and <DownArrow> to cursor to ESS Id.
5. The current ESS Id appears in hex format. Backspace over the existing value, type
a new value in and press <ENTER>.
6. Power the terminal off.
7. Cold boot again.
8. The terminal attempts to associate with an AP.
Successful Association
If the association is successful, the terminal obtains an IP address and bootfile name,
displays the message:
and begins downloading files from the server. During download, the terminal displays a
series of application-defined messages. If the download is successful, the terminal displays
messages indicating success and the application logon screen. Begin operating the
terminal application.
Note: For flash disk terminals, if the terminal is not downloading files
wirelessly, the files are extracted from flash disk and executed.
Halt Batch process Y/N?
CONFIGURATOR X.XX
View Config Parameters
ESS ID
Boot Mode
.
.
.
↑
, Clear, Enter
BOOTP X.XX
Spectrum24® RF Setup
3-9