Symbol PDT 3100 Series Product Reference Manual page 38

PDT 3100 Series Product Reference Guide
4. If you are not using a BOOTP or DHCP server, use the <UpArrow> and
<DownArrow> to cursor to Boot Mode, then enter the following parameters:
• Subnet Mask
• Default Router
• Terminal IP Address
and press <ENTER> after each entry.
5. Press the <clr> key to return to the main menu.
6. Select Exit from the Configurator Menu and press <ENTER> to exit the
Configurator and continue the connection process.
Note: Your changes are saved in the nonvolatile area on the radio card.
The values just entered are not lost if you reboot the terminal.
The terminal attempts to associate with an Access Point (AP) using the default ESS Id.
Unsuccessful Association with AP
If the terminal is unable to associate with the AP (the ESS Id is wrong or forgotten), it
displays the message:
for a few seconds. A second message follows:
The terminal continues trying to connect until the attempt is cancelled.
3-8
CFGXX Ver X.XX
NOT Associated
Terminal cannot associate with AP. You're
out of range or not configured. Ctrl+C to end
or other key to retry. Strike any key when ready.....