Table of Contents
Advertisement
3. BYPASS COPYING
When the desired size of paper is not set in any of the drawers, or when you want to make copies on Full
Bleed or non-standard sized paper, use the sheet bypass.
The modes below are available even in bypass copying if the paper size is specified:
- automatic paper selection
- edge erase
- full image
- centering
- saddle stitching
In these cases, the setting procedures of the following two types of paper are different:
- Bypass copying on standard size and Full Bleed paper
- Bypass copying on non-standard size paper
If you want to make copies on thin paper, thick paper, OHP film, sticker label, special paper, etc., make
bypass copies.
Page 6-11, 6-12
* You can also set THIN paper (17~20 lb.), THICK1 paper (29 lb.bond~60lb.cover/90 lb.index) and OHP
films in the drawers.
Bypass Copy Mode
- Refer to the table below and select the mode corresponding to the paper that has been set. Otherwise,
paper jams may result or the image quality could deteriorate.
- The number of sheets that can be set at a time differs depending on the paper type. Setting more
than the specified number of sheets at a time may cause copier failure or paper jams. Be sure to set
within the specified range.
- It takes from 30 to 90 seconds to switch modes among "PLAIN", "THICK1", "THICK2", "THICK3", "THICK4",
"SPECIAL" and "OHP FILM" for adjustment, and from 30 to 240 seconds between "THIN" and other modes.
- If the BYPASS MISFEED
Page 9-13
- When copying is finished, the lamp of the
CLEAR key, or wait 45 seconds before the bypass copying mode automatically returns to the default mode.
Corresponding Paper Type
THIN (17-20 lb.)
PLAIN (21-28 lb.)
THICK1 (29 lb.bond-90
lb.index/60lb.cover)
THICK2 (-110 lb.index/
75lb.cover)
THICK3 (-140 lb.index/
95lb.cover)
THICK4 (-104 lb.cover)
Sticker labels (THICK2)
Special paper
OHP FILM
* The copier stops its operation when the paper set on the bypass guide has run out even if there is the
same size of copy paper in the drawer.
* When the finisher (optional) is installed, the images may not output easily according to the environ-
ment.
- automatic magnification selection
- image shift
- 2 IN 1 / 4 IN 1
- image repeat
- hole punching
Page 6-9
Page 2-7
symbol flashes, pull out the paper and place it on the sheet bypass again.
FUNCTION CLEAR key lights. Either press the
Paper Size
(Standard size)
LT format: LD, LG, LT, LT-R, ST-R,
COMP(10
1
/
"x14"), 13"LG(8
8
8.5"SQ(8
1
/
"x8
1
/
"), Full Bleed (12"x18")
2
2
A/B format: A3(297x420mm), A4(297x210mm),
A4-R(210x297mm), A5-R(148x210mm),
A6-R(105x148mm), B4(257x364mm),
B5(257x182mm), B5-R(182x257mm),
FOLIO(210x330mm)
(Non-standard size)
Length: 3.9"`-12.0"; Width: 5.8"-18.0"
(Standard size)
LD, LT, LT-R
(Standard size)
LT
- book center erase - dual-page
- trimming/masking
- staple sorting
Page 6-7
130 sheets
1
/
"x13"),
115 sheets (24 lb.)
2
100 sheets (28 lb.)
60 sheets (32 lb.)
60 sheets (60 lb.cover)
40 sheets
40 sheets (80 lb.cover)
40 sheets
40 sheets
40 sheets
40 sheets
- duplex
- mirror image
- magazine sort
FUNCTION
Maximum Capacity
1
2
3
4
5
6
7
8
9
10
11
12
6-5
Advertisement
Table of Contents
