Hole Punching Mode - Toshiba e-STUDIO211c Operator's Manual

5. HOLE PUNCHING MODE

With the optional punching unit attached to the optional finisher (MJ-1019, MJ-1020), you can have your
1
copies punched with holes.
* The paper weight should be in the range of 17 lb.bond to 140 lb.index. Special paper such as OHP films
or labels is excluded.
2
1
Place paper in the drawer(s).
- When using this mode in bypass copying (
3
be sure to specify the paper size.
2 Place the original(s).
4
3 Press the key on the basic screen as shown on the
right (shaded).
5
6
4 Press the HOLE PUNCH key.
7
- If the key for the desired function is not shown, press the
Next key to switch the screen.
Select other copy modes as required.
8
5 Press the
9
Number of punch holes and available paper sizes:
Since the number of punch holes and the distance between
the holes vary depending on the country, purchase a punch
10
unit that meets your requirements. (For details, consult your
service technician.)
11
Japan and most of
Europe (MJ-6002E)
North America
(MJ-6002N)
12
France
(MJ-6002F)
Sweden
(MJ-6002S)
7-8
SELECTING FINISHING MODES (USING THE OPTIONAL FINISHERS)
Page 2-4
Page 2-9
START key.
Number of punch holes and hole diameter
2 holes
(6.5 mm dia.)
2/3 holes switchable
(8.0 mm dia.)
4 holes
(6.5 mm dia.; 80 mm pitch)
4 holes
(6.5 mm dia; 70, 21 mm pitch)
Page 6-5),
Available paper sizes
A3, A4, A4-R, B4, B5, B5-R,
FOLIO
2 holes: LG, LT-R,
3 holes: LD, LT
A3, A4
A3, A4, A4-R, B4, B5, B5-R,
FOLIO