Paper Selection; Automatic Paper Selection (Aps) - Toshiba e-STUDIO211c Operator's Manual

1. PAPER SELECTION

Automatic Paper Selection (APS)

When you place regular-sized originals on the glass or in the reversing automatic document feeder
1
(optional), the built-in sensors automatically work to detect the size of the originals, helping the copier
select and copy on paper that is the same size as the original.
* Depending on the condition of the original, automatic paper selection may not work correctly. In that
case, select the paper size manually.
2
* This mode can only be used for actual-size (100%) copying.
* Original sizes capable of automatic detection
3
1 Place paper in the drawer(s).
4
2 Place the original(s).
3 Confirm that the Automatic Paper Selection mode
5
(default setting) is selected on the basic screen.
6
7
- If the Automatic Paper Selection mode is not selected, press
the ZOOM··· key, then press the APS key on the next
screen.
8
- If the following messages are shown, proceed the indica-
tions as you are told to:
Change direction of original
9
Set correct cassette
10
When the selected drawer size and the original size are the
same, the copier rotates the original data 90° and makes a copy
11
in the same size as the original even if those directions differ
(e.g. a LT-size original is set while the same size paper is set in
R direction). This function, however, is applicable to plain pa-
per only, and is not applicable to ST size originals and paper.
12
Select other copy modes as required.
4 Press the
3-2
SETTING OF BASIC COPY MODES
Page 2-4
Page 2-9
START key.
Page 3-3
Page 2-9