Adding Toner - Konica Minolta 1216 User Manual

Maintenance and Supplies

Adding Toner

When toner supply is low, the ADD TONER indicator light will flash on
the control panel. No further copying will be possible and P25 will flash
in the magnification ratio window.
CAUTION
Before adding toner, carefully read the directions and safety
information included with the toner cartridge. Keep toner away
from children or anyone who may be incapable of handling toner in
a careful manner. Although toner is non-toxic, do not inhale it or
allow it to enter your eyes. In case toner comes in contact with
eyes, consult your physician. Should you have additional
concerns, contact your Konica representative to inquire about the
Material Safety Data Sheet (MSDS).
>PP<
8-8 Maintenance and Supplies
1 To loosen toner, gently strike
the bottom of cartridge against
a solid surface. Turn cartridge
over and repeat procedure.
2 Shake cartridge vigorously.
3 Remove only the bottom plastic
cap.
4 While pressing release buttons
on left and right sides of copier
front door, open the front door.
5 Raise green toner box lid.
Upright
6 Insert cartridge over unit with
>PP< mark facing you,
inserting first the right, then the
left side of the cartridge, until
completely upright.