Mounting The 1552C Access Point Facing Up In A Vault Application - Cisco Aironet 1550 Series Hardware Installation Manual

Chapter 2 Installing the Access Point
Figure 2-21
1
2
Step 5 Position the two bolts on the access point into the quick mount notches on each side of the mounting
bracket (see
Screw a M8 x16 bolt (with flat and lock washers) into the second bolt hole on each side of the access
Step 6
point.
Ensure that the front of the access point is vertical, and tighten the four bolts to 13 to 15 ft lbs
Step 7
(17.6 to 20.3 Nm).
Continue with the
Step 8

Mounting the 1552C Access Point Facing Up in a Vault Application

To mount the 1552C access point on a horizontal surface in a below-ground vault location, follow these
instructions:
Step 1 Use the mounting bracket as a template to mark four screw hole locations on your mounting surface. See
Figure 2-22
mounting holes or the mounting slots.
OL-24247-01
Position of 1552C Access Point in Pole Mount Bracket
M8 x16 bolt (supplied with pole mount kit)
M8 x16 bolt (supplied with pole mount kit)
Figure 2-19). Ensure that the hinged door is facing out.
"Connecting a Cable POC Power to the Access Point" section on page
for the mounting bracket screw hole locations. You can optionally use the individual
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
1 2 3
3 F-connector
Installing the Access Point
2-57.
2-33